End mill
End mill
Material: This T slot cutter end mill is made of high quality high speed steel material, wear resistant and not easy to stick cutter Durable: The high-
A slot mill has two flutes,an endmill usually has four An endmill will always cut out bigger than its diameter,a slot drill should cut to its diameter End mills do not have cutting teeth across all of the end, but have a 'dead' area in the centre, and thus can only be used for milling using the side of the
slot ancient fortune zeus A two flute slot drill will, a four flute end mill cuts oversize, a three flute centre cutting slot drillend mill (as popularised by the Drill bits plunge vertically into material to create holes while end mills typically cut horizontally and laterally, but most mills can actually