secondary transfer slot adjustment holley 4150 hp 750cfm

holley transfer slot adjustment   Dan 11hilo slot

I always try to have the front & rear blades set as close to each other as possible Set the primaries with the transfer slot squared

adjustment screw With the later carbs, the reverse idle works on two circuits, the curb idle and transfer slot Both circuits are adjusted Yes, adjust the butterflies so the transfer slot looks square not a long rectangle About 040 If the transfer slot is covered, you will

dbs slot Most gasoline carburetors will have the throttle plates adjusted with a small length of the idle transfer fuel slot I drill them to 070 and make sure the holes are drilled on the same side of the plate as the transfer slots, and idle air holes Usually about