Fret Tang Size

The laser-cut Acrylic depth stop should be adjusted to cut a slot that is just slightly deeper than the tang of the frets Fret slots which are too deep weaken

Fret Tang Size I would also say the curves are the right way for manufacturing As the tang width of a fretwork is something about a 3d tool path

The laser-cut Acrylic depth stop should be adjusted to cut a slot that is just slightly deeper than the tang of the frets Fret slots which are too deep weaken

tomb raider slot Simply hold the flat edge against the fret tang, note the height of the tang against the reference lines, fit the appropriate curved edge into the slot, and

If your saw has a width of cut of 1mm, use veneer of 1mm thickness Because I wanted quite narrow fret position markers, I used a saw with a width of cut of

fret slot saw This is the saw I use for cutting fret slots - a Zona 35-380 dovetail saw It has the correct kerf of for a fret slot, and has an 8 long blade, is long

Also, as a brief answer to this topic, the standard seems to be a 020 tang in a 023 slot So the slot should be 003 bigger than the tang