Different ways to make a SLOT Boxer's SOLIDWORKS™ Blog

Different ways to make a SLOT Boxer's SOLIDWORKS™ Blog dimension a slot If you want the slots measured with accuracy relative to one another then apply a tolerance to the dimension a slot Geometry of the bracket slot plays a major role in efficient three−dimensional tooth movement during the orthodontic treatment Materials and methodology:

dimension a slot Under the Annotate Tab, pick Centerline Bisector Pick both nodes at the quadrants of the slot as shown below This will create a center line

dimensioning a slot Results: All measured bracket slot heights were within the upper and lower tolerance limits given by DIN 13971-2 Archwires showed measurements outside the The tight key is a connection component fitting into the slot of the shaft and in the hub with torque being transmitted only by the sides of keys The key slots